FixVault
Home › Ford › 1997 › Contour Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 67 (Module Communications Network (F150 & F250 LD)) › Communication Network Diagnostics › Module Version Identification

Module Version Identification

WARNING: This page is about a different car, the 1997 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure may be used to verify correct version of module being tested.
  1. Connect New Generation Star (NGS) scan tool on Data Link Connector (DLC) and perform proper hook-up procedure. See EQUIPMENT HOOK-UP .
    NOTE: If instructed to retrieve PID from a specified test procedure, ensure ignition is in proper position as listed in test procedure, or the test will fail.
  2. Turn ignition switch to RUN position unless otherwise instructed by specified test procedure. Rotate dial on scan tool to DIAGNOSTIC DATA LINK menu and press trigger.
  3. Rotate dial on scan tool to highlight the desired module you wish to access and press trigger. Rotate dial on scan tool to highlight menu MODULE IDENTIFICATION and press trigger. Module version information will be displayed.
About FixVault