FixVault
Home › Ford › 1997 › Probe Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 36 (Seats - Power) › Symptom Testing › Test T: Passenger Seat AUTOGLIDE Does Not Work Properly

Test T: Passenger Seat AUTOGLIDE Does Not Work Properly

WARNING: This page is about a different car, the 1997 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.
  1. Test Seat Operation  - Operate passenger seat in all directions. If passenger seat operates smoothly and completely in all directions, go to next step. If seat does not operate smoothly and completely in all directions, repair passenger seat. See SYMPTOM CHART  table.
  2. Test PID AGLIDEF  - Connect NGS tester to data link connector. Access passenger seat module PID AUTOGLD. Move passenger seat back forward, while observing NGS display. If NGS display did not read FWD, go to next step. If NGS display read FWD, go to step 5).
  3. Test Black/Light Green Wire For Open  - Disconnect seat back switch connector. Check resistance in Black/Light Green wire between passenger seat back switch harness connector and ground. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black/Light Green.
  4. Test Dark Green/Orange Wire For Open  - Disconnect passenger seat module connector C357. See Figure . Check resistance in Dark Green/Orange wire between passenger seat module harness connector C357 and passenger seat back switch harness connector. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Dark Green/Orange wire.
  5. Test PID AUTOGLD  - Access passenger seat module PID AUTOGLD. Move passenger seat back rearward, while observing NGS display. If NGS display did not read RWD, go to next step. If NGS display read RWD, replace passenger seat module.
  6. Test Black/Light Green Wire For Open  - Disconnect seat back switch connector. Check resistance in Black/Light Green wire between passenger seat back switch harness connector and ground. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black/Light Green.
  7. Test Dark Blue/Yellow Wire For Open  - Disconnect passenger seat module connector C357. Check resistance in Dark Blue/Yellow wire between passenger seat module harness connector C357 and passenger seat back switch harness connector. If resistance is 5 ohms or less, passenger seat back switch. If resistance is greater than 5 ohms, repair open in Dark Blue/Yellow wire.
About FixVault