Removal & Installation
WARNING: This page is about a different variant/trim than selected.
Disconnect negative battery cable. Remove any component necessary to gain access to PCM. For PCM location, see PCM LOCATION table. Loosen PCM connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting bolts. Remove PCM cover and PCM. On Pickup, removal of fender liner may be necessary to slide PCM out. To install, reverse removal procedure.
PCM LOCATION
| Model | Location |
|---|---|
| Pickup | Right Side Of Engine Compartment |
| Van | Near Master Cylinder |