FixVault
Home › Ford › 2000 › Contour SVT › Repair and Diagnosis › External Pages › Different car › Section 1272 (Electronic Engine Controls) › Removal And Installation › Throttle Position (TP) Sensor › Installation

Throttle Position (TP) Sensor: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    CAUTION: Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
    CAUTION: Do not use a high speed driver to install the new screws or damage to the TP sensor can occur.
    NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.
  1. Position the new TP sensor and install the 2 new screws.
    • Tighten to 3 Nm (27 lb-in).

    2. Vehicles with 3.0L engine 

  2. Connect the TP sensor electrical connector.

    3. Vehicles with 3.9L engine 

  3. Install the throttle body. For additional information, refer to FUEL CHARGING & CONTROLS - 3.9L .

    4. All vehicles 

  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
About FixVault