FixVault
Home › Ford › 2000 › Contour SVT › Repair and Diagnosis › External Pages › Different car › Section 1385 (HVAC Control System) › Removal And Installation › Blower Motor › Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the blower motor electrical connector.
  2. Detach the wire harness pin-type retainer above the blower motor.
  3. Remove the blower motor vent tube.
  4. Remove 4 blower motor screws.
  5. Remove the blower motor.
    6. CAUTION: Prior to removing a wheel that is to be reused, clean any corrosion from the blower motor shaft to prevent damage to the wheel mounting shaft.
  6. Remove the blower motor wheel clip.
  7. Remove the blower motor wheel.
  8. To install, reverse the removal procedure.
About FixVault