Wiper Motor
WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
Disengage linkage from motor. Disconnect front wiper motor harness connector C125. Connect ammeter between negative battery cable and terminal No. 3 (Black wire) at front wiper motor harness connector C125. For low speed operation, apply battery voltage to terminal No. 4 (White wire) at front wiper motor harness connector C125. For high speed operation, apply battery voltage to terminal No. 5 (Dark Blue/Orange wire) at front wiper motor harness connector C125. Current draw with wiper linkage disconnected should not exceed 3.5 amps at low speed and 5.5 amps at high speed. If current draw is more than specified, replace wiper motor. See WIPER MOTOR under REMOVAL & INSTALLATION.