FixVault
Home › Ford › 2000 › Contour SVT › Repair and Diagnosis › External Pages › Different car › Section 1512 (Electronic Engine Control System - 3.0L (4V)) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCM and the 2 stud bolts.
    • Tighten to 9 Nm (80 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Position the manifold absolute pressure sensor and the wiring harness and install the 2 PCM stud bolt nuts.
    • Tighten to 9 Nm (80 lb-in).
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
About FixVault