FixVault
Home › Ford › 2000 › Contour SVT › Repair and Diagnosis › External Pages › Different car › Section 1512 (Electronic Engine Control System - 3.0L (4V)) › Removal And Installation › Powertrain Control Module (PCM) › Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Any PCM replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  2. Remove the 2 powertrain control module (PCM) stud bolt nuts and position the wiring harness and the manifold absolute pressure sensor aside.
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the 2 stud bolts and the PCM.
About FixVault