Seat - Front: Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front seat and install the 2 front seat track-to-floor bolts.
- Tighten to 48 Nm (35 lb-ft).
- Connect the seat harness electrical connector(s).
- Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
- Move the seat to the most forward position.
- Install the 2 front seat track-to-floor nuts.
- Tighten to 40 Nm (30 lb-ft).
- Install the 2 front seat track-to-floor nut covers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.