Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the retainers and position the fender splash shield aside.
- Disconnect the wheel speed sensor electrical connector.
- Remove the 2 wheel speed sensor harness bracket bolts.
- To install:
- Tighten the bracket-to-wheel knuckle bolt to 23 Nm (17 lb-ft).
- Tighten the bracket-to-body bolt to 7 Nm (62 lb-in).
- To install:
- Remove the front wheel speed sensor bolt from the knuckle and remove the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).
- To install, reverse the removal procedure.