Fuel Conditioning Module - 6.0L Diesel: Disassembly

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

Remove the fuel conditioning module bowl and drain the fuel from the housing.

Fig 1: Fuel Conditioning Module Bowl

GF0012552

Courtesy of FORD MOTOR CO.

Remove and discard the fuel filter and O-ring seal.

Fig 2: Fuel Filter & O-Ring Seal

GF0012553

Courtesy of FORD MOTOR CO.

Remove the bolts and the fuel pump.
- Remove and discard the O-ring seals.

Fig 3: Fuel Pump Bolts

GF0012554

Courtesy of FORD MOTOR CO.

Remove the bolts and the pressure relief valve.
- Remove and discard the O-ring seals.

Fig 4: Pressure Relief Valve Bolts

GF0012555

Courtesy of FORD MOTOR CO.

CAUTION: Do not remove the heater pan or damage to the fuel conditioning module housing will occur.

Remove the bolts and the fuel conditioning module mounting bracket.

Fig 5: Fuel Conditioning Mounting Bracket Bolts

GF0012556

Courtesy of FORD MOTOR CO.