FixVault
Home › Ford › 2000 › Contour SVT › Repair and Diagnosis › External Pages › Different car › Section 2355 (Engine Controls - Electronic Engine Controls - 3.5L) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCM and the bolts.
    • Tighten to 8 Nm (71 lb-in).
  2. Connect the 2 PCM electrical connectors.
  3. Install the battery tray. For additional information, refer to REMOVAL AND INSTALLATION .
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
  5. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, refer to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
  6. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
About FixVault