Section 480 (Manual Transmission): Installation: Transmission
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL CHART
| Item | Specification |
|---|---|
| MERCON® Multi-Purpose (ATF) Transmission Fluid XT-2-QDX |
- To install, reverse the removal procedure.
NOTE:
Before securing the engine to the transmission, connect the hydraulic line to the clutch slave cylinder.
NOTE:
Install the transfer case with a new gasket. Tighten the bolts that retain the transfer case to the extension housing in a clockwise direction beginning with the upper LH bolt.
NOTE:
Install the front driveshaft with new bolts and washers and the rear driveshaft with new bolts.
NOTE:
Align the index marks when installing the front and rear driveshafts.
NOTE:
Check and, if necessary, fill the transmission with the specified type and quantity of fluid.