Gearshift Lever: Installation
WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Position the gearshift lever assembly in the vehicle.
- Install the 4 gearshift lever nuts.
- Tighten to 23 Nm (17 lb-ft).
- Connect the selector cable.
- Connect the shift cable.
- Tighten the nut to 9 Nm (80 lb-in).
- Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
- Install the 2 console screws to the shifter base, the 2 front console center bolts and then install the 2 rear side console bolts.
- Install the floor console finish panel.
- Install the gearshift knob.