FixVault

Wiper System And Washer System: Self-Diagnostics

  1. If concern remains after inspection, connect New Generation Star (NGS) tester to DLC located below instrument panel. Perform data link diagnostic test. If NGS responds with NO RESPONSE/NOT EQUIPPED for Generic Electronic Module (GEM), go to TEST K  . If GEM passes diagnostic data link test, retrieve continuous DTCs and perform self-test diagnostics for GEM.
  2. If GEM DTCs related to the concern are retrieved, go to appropriate SYSTEM TEST. See GEM DTC TEST INDEX  table. If no DTCs related to concern are retrieved, perform appropriate test based on symptom. See SYMPTOM TEST INDEX  table under SYSTEM TESTS. For GEM DTCs not covered in this article, see MODULE COMMUNICATIONS NETWORK - SABLE & TAURUS.
GEM DTC TEST INDEX (1)

DTC (1) Description Go To Test
B1432 Wiper Park Relay Circuit Short To Power A 
B1434 Wiper High/Low Speed Relay Circuit Failure C 
B1436 Wiper High/Low Speed Relay Short To Power C 
B1438 Wiper Mode Select Switch Circuit Failure (2)(4)
B1441 Wiper Mode Select Switch Short To Ground C 
B1446 Wiper Park Sense Circuit Failure (2)(4)
B1448 Wiper Park Sense Circuit Short To Power (3)(4)
B1450 Wiper/Washer Delay Switch Circuit Failure (4)(5)
B1458 Wiper/Washer Pump Motor Relay Circuit Failure (5)(6)
B1460 Wiper Washer Pump Motor Relay Coil Short To Power D 
B1465 Wiper Park Relay Circuit Open (2)(3)
B1466 Wiper High/Low Speed Not Switching (2)(3)(4)
(1) Codes listed in this table are only for testing covered in this article. For complete DTC listing, see MODULE COMMUNICATIONS NETWORK - SABLE & TAURUS.
(2) If windshield wipers are inoperative, go to TEST A  .
(3) If windshield wipers stay on continuously, go to TEST B  .
(4) If windshield wipers do not operate correctly, go to TEST C  .
(5) If windshield washer is inoperative, go to TEST D  .
(6) If windshield washer stays on continuously, go to TEST E  .