Material Specifications
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS TABLE
| Item | Specification |
|---|---|
| Motorcraft® Premium Cooling System Flush VC-1 |
ESR-M14P7-A |
NOTE:
To remove rust, sludge and other foreign material from the cooling system, use cooling system flush that is safe for use with aluminum radiators. For additional information, refer to SPECIFICATIONS in this service information. This cleaning restores cooling system efficiency and helps prevent overheating. A pulsating or reversed direction of flushing water will loosen sediment more quickly than a steady flow in the normal coolant flow direction. In severe cases where cleaning solvents will not clean the cooling system efficiently, it will be necessary to use the pressure flushing method using cooling system flusher. Dispose of old coolant and flushing water contaminated with antifreeze and cleaning chemicals in accordance with local, state or federal laws.
- Add Premium Cooling System Flush to the cooling system and follow the directions on the package.
- Remove the radiator. For additional information, refer to RADIATOR in this service information.
- Backflush the radiator with the radiator in an upside-down position and a high-pressure hose in the lower hose location.
- Remove the thermostat housing. For additional information, refer to THERMOSTAT HOUSING in this service information.
- Position a high-pressure water hose into the engine through the upper radiator hose and backflush the engine.
NOTE:
Radiator internal pressure must not exceed 138 kPa (20 psi). Damage to the radiator can result.
NOTE:
Thermostat and housing are serviced as an assembly.