FixVault
Home › Ford › 2000 › Windstar Limited › Repair and Diagnosis › External Pages › Different car › Section 216 (Power Steering System) › Removal And Installation › Pump-CII › Removal

Removal And Installation: Pump-CII: Removal

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. For additional information, refer to ACCESSORY DRIVE .
  2. Disconnect the power steering reservoir pump hose (3E525).
    Fig 1: Disconnecting Power Steering Reservoir Pump Hose
    G01306403Courtesy of FORD MOTOR CO.
  3. Disconnect the power steering hose (3A719). Remove and discard the seal.
    Fig 2: Disconnecting Power Steering Hose
    G01306404Courtesy of FORD MOTOR CO.
  4. Remove the four bolts, two brackets and power steering pump (3A674).
    Fig 3: Removing Four Bolts
    G01306405Courtesy of FORD MOTOR CO.
  5. Remove the power steering pump pulley. For additional information, refer to PULLEY - CIII PUMP .
About FixVault