Side Impact Sensor: Removal
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
A side impact sensor is located at the base of each B-pillar.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
- Remove the lower B-pillar trim panel. For additional information, refer to the Removal and Installation procedure in INTERIOR TRIM & ORNAMENTATION article.
- Remove the side impact sensor with bracket.
- Disconnect the electrical connector.
- Remove the bolt.
- Remove the bolt.
- Remove the side impact sensor with bracket.
NOTE:
The side impact sensor bolts must be removed in the sequence shown in following illustration.