Making Changes To The TCM Calibration

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

If the TCM does not complete the reflash after two consecutive attempts, follow the instructions listed below:

If the TCM reprogramming aborts during the procedure:
- Reprogram the TCM again.
- After the TCM reprogramming is successfully completed, clear the continuous DTCs in the PCM and the TCM.
If the TCM reprogramming aborts immediately after the start:

Turn the ignition OFF.
Disconnect the PCM body/cowl connector, and leave it disconnected.
Turn the ignition ON.
Start the TCM reprogramming.
After the TCM reprogramming is successfully completed, turn the ignition OFF and connect the PCM body/cowl connector.
Clear any PCM and TCM DTCs that may have been stored during reprogramming.