Front Impact Severity Sensor: Removal
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag SRS is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Install and properly position the sensor or any other damaged SRS components whether or not the air bag is deployed.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Depower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
- Position the hood latch assembly aside.
- Loosen the hood latch nut.
- Remove the hood latch bolts.
- Position the hood latch aside.
- Detach the wiring harness pin-type retainers.
- Remove the radiator support bracket bolt.
- Remove the front impact severity sensor bolt.
- Disconnect the electrical connector and remove the front impact severity sensor.
NOTE:
Mark the hood latch position prior to removal of the bolts.