Torque Converter Flushing
- Partially fill the torque converter using clean automatic transmission fluid.
- Hand agitate the converter, then thoroughly drain the fluid.
- Repeat this procedure until the converter is clean.
- After flushing, drain the remainder of the solvent.
- Add 1.9 liters (2 quarts) of clean automatic transmission fluid and agitate by hand.
- Thoroughly drain the converter.
- Refill the torque converter with clean automatic transmission fluid and install into transaxle.
CAUTION:
Mineral spirits used to clean the torque converter must be fresh, non-chlorinated and non-halogenated. Do not
use water-based solvents or damage to the transaxle or torque converter can occur. If local ordinances state that water-based solvent must be used, use clean automatic transmission fluid as recommended for this transaxle.