FixVault
Home › Ford › 2001 › Mustang Base, 2D Convertible, Automatic › Repair and Diagnosis › Body & Frame › Windows › Power Window System › Removal & Installation › Window Regulator › Removal & Installation (Front)

Removal & Installation (Front)

  1. Remove door trim panel. See DOOR TRIM PANEL  . Remove door speaker. Remove interior weatherstrip from door frame. Remove 2 door window glass inner stabilizer bolts at top of door frame. Remove 2 door window glass inner stabilizers. Remove door window stop bracket screws, located near top of inside door frame. Remove door window stop brackets.
  2. Remove exterior weatherstrip rivet at top rear of door frame. Remove exterior weatherstrip. Remove 2 window regulator rivets. Tip front edge of window glass down to clear door filler. Remove door window glass. Disconnect window motor harness connector. Remove 2 window regulator run channel screws located in middle of door frame. Remove window regulator run channel. Remove window regulator.
  3. To install, reverse removal procedure. Transfer parts to new window regulator as necessary. Tighten window regulator run channel screws to 80 INCH lbs. (9 N.m). Adjust door window glass. See DOOR WINDOW HEIGHT STOP  and STABILIZER  under ADJUSTMENTS.
About FixVault