Fuel Conditioning Module - 6.0L Diesel: Assembly

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the fuel conditioning module mounting bracket and bolts.
- Tighten to 17 Nm (13 lb-ft).

Fig 1: Fuel Conditioning Mounting Bracket Bolts

Courtesy of FORD MOTOR CO.

Install new O-ring seals on the fuel pump and lubricate with clean engine oil.

Fig 2: Fuel Pump O-Ring Seals

Courtesy of FORD MOTOR CO.

Install the fuel pump and mounting bolts.
- Tighten to 5 Nm (44 lb-in).

Fig 3: Fuel Pump Bolts

Courtesy of FORD MOTOR CO.

Install new O-ring seals on the relief valve cover and apply clean engine oil.

Fig 4: Relief Valve Cover O-Ring Seals

Courtesy of FORD MOTOR CO.

Install the pressure relief valve and bolts.
- Tighten to 5 Nm (44 lb-in).

Fig 5: Pressure Relief Valve Bolts

Courtesy of FORD MOTOR CO.

Install a new O-ring seal and fuel filter on the fuel conditioning module bowl. Lubricate the O-ring seal with clean engine oil.

Fig 6: Fuel Filter & O-Ring Seal

Courtesy of FORD MOTOR CO.

Install the fuel conditioning module bowl.
- Tighten to 13 Nm (10 lb-ft).
- Rotate the fuel conditioning module bowl until the electrical connectors line up.

Fig 7: Fuel Conditioning Module Bowl

Courtesy of FORD MOTOR CO.