Removal And Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct retention of these parts.
- Remove and discard the stabilizer bar link lower nut and disconnect the link from the axle.
- To install, tighten to 80 Nm (59 lb-ft).
- Using a suitable jack, support the front axle.
- Remove and discard the shock absorber upper nut and bushing.
- To install, tighten to 63 Nm (46 lb-ft).
- Remove and discard the spring upper bracket bolt and remove the spring upper bracket.
- To install, tighten to 23 Nm (17 lb-ft).
- Using the jack, lower the front axle and remove the spring.
- To install, reverse the removal procedure.
CAUTION:
The axle must be supported throughout the procedure to prevent damage to the front brake hose.
NOTE:
When tightening the shock absorber upper nut, make sure that the upper shock rod is centered in the frame.
CAUTION:
Use care when lowering the jack, or damage to the front brake hose may occur.