FixVault
Home › Ford › 2001 › ZX2 Automatic › Repair and Diagnosis (Single Page) › Transmission › Automatic Trans › Diagnosis - Automatic Transmission › Removal & Installation › Powertrain Control Module › Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable. Remove the parking brake and shift consoles. Move both front seats forward. Remove the two screws from the parking brake console panel (one each side). Engage parking brake. Pull upward and remove the parking brake console panel. Position both front seats rearward.
  2. Remove the shift console panel screws. Remove the four pushpins (two each side). Place the gearshift lever into the low "L" gear position. Remove the beverage holder from the shift console base. Lift upward and remove the shift console panel.
  3. Place the gearshift lever in LOW and remove the transmission control selector dial bezel screws. Turn the transmission control selector dial bezel one-quarter turn counterclockwise. Loosen the bolt and disconnect the PCM electrical connector. Loosen PCM connector retaining bolt, if equipped. Unplug harness connector from PCM. Remove 2 PCM mounting bolts. Remove PCM cover and PCM. To install, reverse removal procedure. See PROGRAMMING  .
About FixVault