Power Mirror Control Switch
Remove power mirror control switch. See POWER MIRROR CONTROL SWITCH under REMOVAL & INSTALLATION. Measure resistance between specified terminals while operating switch as specified. See POWER MIRROR SWITCH TEST table. For power mirror control switch terminals identification, see Fig 1. Resistance in all tests should be less than 5 ohms. If switch fails any portion of test, replace switch.
POWER MIRROR SWITCH TEST
| Switch Position | Measure Between Terminals No. | |
|---|---|---|
| Driver's Side Power Mirror | ||
| Up | 1 & 7; 5 & 6 | |
| Down | 1 & 5; 7 & 5 | |
| Left | 1 & 4; 5 & 6 | |
| Right | 1 & 5; 4 & 6 | |
| Passenger's Side Power Mirror | ||
| Up | 1 & 8; 5 & 6 | |
| Down | 1 & 5; 6 & 8 | |
| Left | 1 & 3; 5 & 6 | |
| Right | 1 & 5; 3 & 6 | |