FixVault
Home › Ford › 2002 › Escape 3.0 1, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Overhaul- Automatic Transmission › Disassembly & Assembly Of Subassemblies › Chain Sprockets › Assembly

Chain Sprockets: Assembly

  1. Position the No. 16 reverse/overdrive ring gear bearing on the special tools.
    • Position the bearing with the part number facing toward the handle of the special tool.
    Fig 1: Positioning No. 16 Reverse/Overdrive Ring Gear Bearing On The Special Tools
    G02050539Courtesy of FORD MOTOR CO.
    2. NOTE: The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
    Fig 2: Installing No. 16 Reverse/Overdrive Ring Gear Bearing
    G02050540Courtesy of FORD MOTOR CO.
  2. Using the special tools, install the No. 16 reverse/overdrive ring gear bearing.
  3. Position the No. 17 stator support bearing on the special tools.
    • Position the bearing with the part number facing toward the handle of the special tool.
    Fig 3: Positioning No. 17 Stator Support Bearing On The Special Tools
    G02050541Courtesy of FORD MOTOR CO.
    4. NOTE: The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
    Fig 4: Installing No. 17 Stator Support Bearing Into The Stator Support Sprocket
    G02050542Courtesy of FORD MOTOR CO.
  4. Using the special tools, install the No. 17 stator support bearing into the stator support sprocket.
About FixVault