Fill Procedure

WARNING: This page is about a different car, the 2002 Ford ZX2. However, it is still accessible from the selected car via links, so may be relevant.

Park the vehicle on level ground and apply the parking brake.
Disconnect the vehicle speed sensor (VSS) electrical connector.

Fig 1: Disconnecting Vehicle Speed Sensor (VSS) Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the VSS.

Fig 2: Removing Bolt And VSS
Courtesy of FORD MOTOR CO.
Place a funnel into the VSS hole.

Fig 3: Adding Transaxle Fluid
Courtesy of FORD MOTOR CO.
Add the specified transaxle fluid until the full level on the VSS is reached.

Fig 4: Identifying Transaxle Fluid Level On VSS
Courtesy of FORD MOTOR CO.
Install the VSS and the bolt.

Fig 5: Installing VSS And Bolt
Courtesy of FORD MOTOR CO.
Connect the VSS electrical connector.

Fig 6: Connecting VSS Electrical Connector
Courtesy of FORD MOTOR CO.