FixVault
Home › Ford › 2002 › Excursion 7.3 F, RWD › Repair and Diagnosis › External Pages › Different car › Section 1848 (Manual Transaxle/Transmission External Controls) › Removal And Installation › Gearshift Lever › Installation

Gearshift Lever: Installation

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the gearshift lever.
  2. Connect the select cable.
    3. Fig 1: Select Cable
    GF0025433Courtesy of FORD MOTOR CO.
  3. Connect the gearshift cable.
    4. Fig 2: Gearshift Cable
    GF0025434Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
  4. Install the 2 gearshift cable clips.
    5. Fig 3: Gearshift Cable Clips
    GF0025435Courtesy of FORD MOTOR CO.
  5. Install the 4 gearshift lever bolts.
    • Tighten to 25 Nm (18 lb-ft).
  6. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  7. Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
About FixVault