FixVault
Home › Ford › 2002 › Focus SVT › Repair and Diagnosis › External Pages › Different car › Section 344 (Automatic Transmission) › Disassembly And Assembly Of Subassemblies › Driven Sprocket Support › Assembly

Driven Sprocket Support: Assembly

WARNING: This page is about a different car, the 2002 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install a new driven sprocket bearing. Using the special tools and an arbor press install a new driven sprocket bearing.
    Fig 1: Installing Driven Sprocket Bearing
    G02145945Courtesy of FORD MOTOR CO.
  2. Make sure that the seals are mated correctly during installation.
    Fig 2: Identifying Proper Seal Installation Position
    G02145946Courtesy of FORD MOTOR CO.
    3. CAUTION: The seal rings must be installed correctly. Transmission failure could result.
    Fig 3: Installing Teflon Seals And Thrust Washer
    G02145947Courtesy of FORD MOTOR CO.
  3. Install new Teflon® seals and the No. 5 thrust washer.
About FixVault