FixVault
Home › Ford › 2003 › Escape 3.0 1, 4WD › Repair and Diagnosis › External Pages › Different car › Section 249 (Engine - 4.2L) › In-Vehicle Repair › Engine Dynamic Balance Shaft › Installation

Engine Dynamic Balance Shaft: Installation

WARNING: This page is about a different car, the 2003 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the balance shaft bearings with clean engine oil. Install the engine dynamic balance shaft.
    Fig 1: Identifying Lubricate Point
    G01535904Courtesy of FORD MOTOR CO.
  2. Install the engine balance shaft drive gear.
    • The timing marks on the drive and driven gear must align.
    Fig 2: Aligning Timing Marks On Drive And Driven Gear
    G01535905Courtesy of FORD MOTOR CO.
  3. Install the timing chain vibration damper.
    Fig 3: Installing Timing Chain Vibration Damper
    G01535906Courtesy of FORD MOTOR CO.
  4. Install the crankshaft sprocket, camshaft sprocket and timing chain as an assembly.
    • Timing marks on the gears and keyways on the shafts must align.
    Fig 4: Aligning Timing Marks On Gears And Keyways On Shafts
    G01535907Courtesy of FORD MOTOR CO.
  5. Install the synchronizer drive gear.
    Fig 5: Installing Synchronizer Drive Gear
    G01535908Courtesy of FORD MOTOR CO.
  6. Install the engine front cover. For additional information, refer to ENGINE FRONT COVER .
About FixVault