Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel and tire. For additional information, refer to WHEEL AND TIRE .
Detach the grommet from the body and pull the connector through the hole.

Fig 1: Pulling Connector Through Hole
Courtesy of FORD MOTOR CO.
Disconnect the sensor wiring.

Fig 2: Disconnecting Sensor Wiring
Courtesy of FORD MOTOR CO.
Detach the retainer.

Fig 3: Detaching Retainer
Courtesy of FORD MOTOR CO.
Remove the bolts.

Fig 4: Removing Bolts
Courtesy of FORD MOTOR CO.

NOTE: Clean off any dirt that may have collected around the sensor before removal.

Fig 5: Removing Bolt And Sensor

Courtesy of FORD MOTOR CO.

Remove the bolt and sensor.

NOTE: Thoroughly clean the mounting surface.

To install, reverse the removal procedure.