FixVault
Home › Ford › 2003 › Excursion 7.3 F, 4WD › Repair and Diagnosis › External Pages › Different car › Section 242 (Automatic Transmission) › Disassembly And Assembly Of Subassemblies › Low One-Way Clutch Assembly › Assembly

Low One-Way Clutch Assembly: Assembly

WARNING: This page is about a different car, the 2003 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Outer tabs of the roller assembly must face up.
    Fig 1: Installing Roller Assembly
    G01390789Courtesy of FORD MOTOR CO.
  1. Install the roller assembly into the outer race with the groove facing up.
    2. NOTE: To aid in inner race installation, rotate the inner race clockwise during installation
    Fig 2: Installing Inner Race With Grooves Facing Up
    G01390790Courtesy of FORD MOTOR CO.
  2. Install the inner race with the grooves facing up.
  3. Check the operation of the one-way clutch as follows:
    1. Hold the outer race.
    2. Rotate the inner race clockwise. It should rotate with a slight drag without attempting to rotate the outer race.
    3. Rotate the inner race counterclockwise. The inner race should rotate the outer race.
      Fig 3: Checking Operation Of One-Way Clutch
      G01390791Courtesy of FORD MOTOR CO.
About FixVault