Section 160 (Front Suspension System): Description

WARNING: This page is about a different car, the 2004 Ford Escape, 2003 Ford Escape, and 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Front suspension is MacPherson strut type using gas-pressurized struts and cast steering knuckles. Strut assembly includes a rubber isolated top mount and a thrust bearing. Strut assembly is bolted to strut tower and steering knuckle. A pinch joint is built into steering knuckle to retain ball joint stud. A control arm is attached to underbody and steering knuckle. A stabilizer bar is connected to both struts and secured to crossmember at bracket assemblies. Tie rod ends connect to steering knuckle.

Installation of new front strut assemblies and/or springs in pairs is not required by manufacturer. Install front suspension assemblies and/or springs one at a time as required. Ball joints and control arm pivot bushings may be replaced individually.