Intake Manifold Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Position a new lower intake manifold gasket and the upper intake manifold on the lower intake manifold and loosely install the bolts.

Fig 1: Positioning A New Lower Intake Manifold Gasket And Upper Intake Manifold On Lower Intake Manifold
Courtesy of FORD MOTOR CO.
Tighten the bolts in two stages, using the sequence shown.
- Stage 1: Tighten to 2 Nm (18 lb-in).
- Stage 2: Tighten to 10 Nm (89 lb-in).
Fig 2: Intake Manifold Bolt Tightening Sequence
Courtesy of FORD MOTOR CO.
Lubricate the new O-ring seals with engine oil.

Fig 3: Lubricating New O-Ring Seals With Engine Oil
Courtesy of FORD MOTOR CO.
Install the fuel injector supply manifold.
- Position the fuel injection supply manifold.
- Install the four bolts.
Fig 4: Installing Fuel Injection Supply Manifold
Courtesy of FORD MOTOR CO.
Install the engine coolant temperature (ECT) sensor.

Fig 5: Installing Engine Coolant Temperature (ECT) Sensor
Courtesy of FORD MOTOR CO.