FixVault
Home › Ford › 2004 › Cutaway 6.8 S › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock Brake System - Anti-Lock Control › Removal And Installation › Anti-Lock Brake System (Abs) Module › Removal and Installation

Removal and Installation

NOTE:
The ABS module mounts to the HCU on a bracket on L/H inner fender well in engine compartment.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Position the radiator coolant reservoir aside.
    1. Remove the bolts.
    Fig 1: Radiator Coolant Reservoir Bolt Torque Specifications
    G02761374Courtesy of FORD MOTOR CO.
  3. Remove the four screws and position the ABS module to gain access to the electrical connector.
    Fig 2: ABS Module Screw Torque Specifications
    G02761375Courtesy of FORD MOTOR CO.
  4. Disconnect the ABS module electrical connector.
    1. Release the lock tab.
    2. Pull the connector from the module.
    Fig 3: Disconnecting ABS Module Electrical Connector
    G02761376Courtesy of FORD MOTOR CO.
  5. Remove the ABS module.
    1. Lift the ABS module slightly and disconnect the ABS pump motor electrical connector.
    2. Remove the ABS module from the vehicle.
    Fig 4: Removing ABS Module
    G02761377Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
About FixVault