Diagnostic Flow Chart

DIAGNOSTIC FLOW CHART

WARNING: If equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM for Important Safety Warnings. Know and understand the customer concerns Check the fluid level and condition Verify the concern by operating the vehicle Check for non-factory-installed items and verify correct installation Check the shift linkage adjustments Check TSBs and OASIS messages for vehicle concerns Carry out quick test both KOER and KOEO Record all codes 1) Did you record any diagnostic trouble codes	Yes	REPAIR all hard diagnostic trouble codes. FOLLOW the pinpoint tests. See INTRODUCTION - GASOLINE article first, then this Workshop Manual.
	No	REFER to DIAGNOSIS BY SYMPTOM in this section, then GO to Step 5.
2) Are any continuous test memory codes present?	Yes	CLEAR codes and CARRY OUT drive cycle test.
2) Are any continuous test memory codes present?	No	GO to Step 4.
3) Did the continuous test memory codes reappear?	Yes	REPAIR all continuous test memory codes. FOLLOW the pinpoint tests. See INTRODUCTION - GASOLINE article then the transmission reference manual, then this workshop manual, then GO to Step 4.
3) Did the continuous test memory codes reappear?	No	GO to Step 4.
4) Is the concern repaired?	Yes	CARRY OUT the final quick test to verify that no diagnostic trouble codes are present. CLEAR memory codes.
4) Is the concern repaired?	No	REFER to DIAGNOSIS BY SYMPTOM in this section.
5) Are there any electrical concerns?	Yes	INSTALL the diagnostic tool and CARRY OUT the output state control test, then GO to Step 6.
5) Are there any electrical concerns?	No	REFER to the to diagnose and REPAIR the concern, then GO to Step 7.
6) Was the transmission concern corrected when the diagnostic tool was installed?	Yes	See INTRODUCTION - GASOLINE article , intermittent fault diagnosis section and use the diagnostic tool to diagnose cause of concern in the processor, vehicle harness or external inputs (sensors or switches).
	No	REFER to the hydraulic and mechanical routine to diagnose the concern, then GO to Step 7.
7) Is the concern repaired?	Yes	CARRY OUT the final quick test to verify that no diagnostic trouble codes are present. CLEAR memory codes.
7) Is the concern repaired?	No	Repaeat testing as necessary.