FixVault
Home › Ford › 2005 › Focus ZXW SES, Standard › Repair and Diagnosis › Engine Performance › Engine Ignition System › Removal And Installation › Ignition Coil-On-Plug › Removal and Installation

Removal and Installation

  1. Disconnect the electrical connector.
    Fig 1: Disconnecting Ignition Coil Electrical Connector
    G03951082Courtesy of FORD MOTOR CO.
  2. Remove the bolt and the ignition coil.
    Fig 2: Removing Ignition Coil Bolt
    G03951083Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
    • Apply silicone dielectric compound to the inside of the ignition coil boot.
About FixVault