FixVault
Home › Ford › 2005 › Freestar Base › Repair and Diagnosis (Single Page) › Engine Mechanical › Fuel System › Fuel System & Engine Control System › Removal And Installation › Fuel Pump Driver Module (FPDM) › Removal And Installation

Removal And Installation

  1. Remove the LH lower B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the fuel pump driver module electrical connector.
  3. Remove the fuel pump driver module nuts.
    • To install, tighten to 5 Nm (44 lb-in).
  4. Remove the fuel pump driver module.
  5. To install, reverse the removal procedure.
About FixVault