Left Power Sliding Door Module (LPSDM)
DTC CHART (DTC) LIST
| DTC | Description | Source | Perform Test |
|---|---|---|---|
| B1342 | ECU Is Defective | LPSDM | CLEAR the DTCs. CARRY OUT the LPSDM self-test. If DTC B1342 is retrieved, INSTALL a new LPSDM. |
| B2238 | Broken Cable Detected | LPSDM | GO to PINPOINT TEST C . |
| B2270 | PSD Exceeded Time Allowed To Cinch Door (Exceeded Time Allowed To Reach Primary Latch Position After Reaching Secondary Latch Position) | LPSDM | GO to PINPOINT TEST D . |
| B2271 | PSD Did Not Reach Full-Open Position During Self-Test | LPSDM | GO to PINPOINT TEST E . |
| B2363 | Position Sensor System Failure | LPSDM | GO to PINPOINT TEST F . |
| B2364 | Fuel Door Interlock Open Circuit | LPSDM | GO to PINPOINT TEST G . |
| B2365 | B-Pillar Power Sliding Door Open/Close Switch Circuit Short To Ground | LPSDM | GO to PINPOINT TEST H . |
| B2366 | PSD Open/Close Switch Circuit Short To Ground | LPSDM | GO to PINPOINT TEST I . |
| B2374 | PSD Detent Switch Circuit Short To Ground | LPSDM | GO to PINPOINT TEST J . |
| B2483 | Enable Signal Open Circuit (Park) | LPSDM | GO to PINPOINT TEST K . |
| B2589 | No PSD Detent Switch Detected On Closing And Door Reversed | LPSDM | GO to PINPOINT TEST L . |
| B2591 | No PSD Detent Switch Detected On Unlatch | LPSDM | GO to PINPOINT TEST M . |
| B2592 | Door Not Pulled Into Primary During Power Close And High Duty Cycles | LPSDM | GO to PINPOINT TEST N . |
| B2593 | Door Reversed While Closing Due To An Obstacle | LPSDM | GO to PINPOINT TEST O . |
| B2594 | No Movement Was Detected After An Unlatch During A Power Open Operation | LPSDM | GO to PINPOINT TEST P . |
| B2603 | PSD Not Fully Closed During Self-Test | LPSDM | GO to PINPOINT TEST Q . |
| B2604 | PSD On/Off Switch Open Circuit | LPSDM | GO to PINPOINT TEST R . |
| B2605 | Disable Signal Open Circuit - VSS greater than 5 km/h (3 mph) | LPSDM | GO to PINPOINT TEST S . |