Transmission Range (TR) Sensor Adjustment: Adjust

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the shift cable from the manual control lever.

Fig 1: Locating Shift Cable Eyelet At Manual Control Lever
Courtesy of FORD MOTOR CO.
Loosen the screws.

Fig 2: Loosening TR Sensor Screws
Courtesy of FORD MOTOR CO.

CAUTION: The digital TR sensor must fit flush against the case. Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 3: Aligning TR Sensor
  Courtesy of FORD MOTOR CO.
Install the shift cable to the manual control lever.

Fig 4: Locating Transmission Shift Cable At Manual Control Lever
Courtesy of FORD MOTOR CO.
Verify that the shift cable is adjusted correctly. For additional information, refer to SELECTOR LEVER CABLE ADJUSTMENT .