Extension Housing Seal: Installation

NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.

Fig 1: Installing Extension Housing Seal

Courtesy of FORD MOTOR CO.

Using the special tool, install the new extension housing seal.
Using the special tools, install the output flange.

Fig 2: Installing Output Flange
Courtesy of FORD MOTOR CO.
Install a new nut.
- Tighten to 130 Nm (96 lb-ft).
  
  Fig 3: Installing Nut
  Courtesy of FORD MOTOR CO.
Install the 4 transmission crossmember-to-floor pan screws only.
- Tighten to 63 Nm (46 lb-ft).
  
  Fig 4: Installing Transmission Crossmember-To-Floor Pan Screws
  Courtesy of FORD MOTOR CO.
Install the driveshaft. For additional information, refer to DRIVESHAFT .
Check the transmission fluid level. For additional information, refer to TRANSMISSION FLUID LEVEL CHECK .