FixVault
Home › Ford › 2005 › Ranger 2D Pickup, 2.3 D, Automatic › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Electronic Engine Control System › Removal And Installation › Powertrain Control Module (PCM) › Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the powertrain control module (PCM) electrical connector.
    Fig 1: Removing Powertrain Control Module (PCM) Electrical Connector
    G03956400Courtesy of FORD MOTOR CO.
  3. Remove the nuts and the PCM cover.
    Fig 2: Removing Powertrain Control Module (PCM) Cover Nuts
    G03914596Courtesy of FORD MOTOR CO.
  4. Remove the PCM.
  5. To install, reverse the removal procedure.
About FixVault