Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- If servicing the powertrain control module (PCM), connect the diagnostic tool to the vehicle. Allow the diagnostic tool to identify the vehicle and obtain configuration data.
- All programmable module information will automatically be retrieved by the WDS.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the air cleaner assembly and air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
- Disconnect the 3 PCM electrical connectors.
- Remove the 2 retaining nuts and PCM.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
NOTE:
Refer to DIAGNOSTIC METHODS -- GASOLINE MODELS
for correct Worldwide Diagnostic System (WDS) hook-up procedure.