FixVault
Home › Ford › 2006 › Escape Base, 3.0 1, FWD › Repair and Diagnosis › Steering › Power Steering › Power Steering System › Removal And Installation › Power Steering Control (PSC) Module › Removal and Installation

Removal and Installation

  1. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - HYBRID .
    • Position the BJB aside.
  2. Disconnect the power steering control module electrical connectors.
  3. Remove the 2 power steering control module nuts.
    • To install, tighten to 23 Nm (17 lb-ft).
  4. Remove the power steering control module ground cable bolt.
  5. Remove the power steering control module nuts from inside the vehicle.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. Remove the power steering control module.
  7. To install, reverse the removal procedure.
About FixVault