Torca® Clamp

NOTE: Do not tighten the new Torca® clamp until the exhaust system has been aligned.

Remove the nut from the Torca® clamp.
Grind the spot weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and, using an abrasive pad, clean the Torca® clamp surface area of any rust on the pipe.
Position a new Torca® clamp 3-4 mm (0.12-0.16 in) from the button slot.

Fig 1: Identifying Torca® Clamp Position
Courtesy of FORD MOTOR CO.
Rotate the Torca® clamp until it is 83 degrees to 93 degrees from slot in the side of pipe.

Fig 2: Identifying Torca® Clamp Tightening Angle
Courtesy of FORD MOTOR CO.
Spot-weld the Torca® clamp to the pipe 180 degrees from the Torca® clamp hardware.

Fig 3: Identifying Torca® Clamp Tightening Angle
Courtesy of FORD MOTOR CO.