Output Shaft Speed (OSS) Sensor: Installation

NOTE: Apply a light coat of clean transmission fluid to the O-ring before installation.

Install the OSS sensor.
- Tighten to 10 Nm (89 lb-in).
- Connect the electrical connector.
  
  Fig 1: Locating Electrical Connector
  Courtesy of FORD MOTOR CO.
Lower vehicle.
Check the transmission fluid level and add automatic transmission fluid as necessary.

Fig 2: Identifying Transmission Fluid Level Gauge
Courtesy of FORD MOTOR CO.
Start the engine and move the transaxle range selector lever through all gear positions.