FixVault
Home › Ford › 2006 › Mustang Base, 2D Convertible, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › In-Vehicle Repair › Extension Housing Seal › Installation

Extension Housing Seal: Installation

NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.
  1. Using the special tool, install the new extension housing seal.
    Fig 1: Identifying Special Tool To Extension Housing Seal
    G04696212
  2. Using the special tools, install the output flange.
    Fig 2: Identifying Special Tools To Output Shaft Flange
    G04696213
  3. Install a new nut.
    • Tighten to 130 Nm (96 lb-ft).
      Fig 3: Locating Nut
      G04696214
  4. Install the 4 transmission crossmember-to-floor pan screws only.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 4: Locating Transmission Crossmember-To-Floor Pan Screws
      G03982786
  5. Install the driveshaft. For additional information, refer to DRIVESHAFT .
  6. Check the transmission fluid level. For additional information, refer to TRANSMISSION FLUID LEVEL CHECK  in this article.
About FixVault