OSC Procedures
WARNING: This page is about a different variant/trim than selected.
- Carry out visual inspection and vehicle preparation as necessary.
- Select "Vehicle and Engine Selection" menu.
- Select appropriate vehicle and engine.
- Select "Diagnostic Data Link."
- Select "Powertrain Control module."
- Select "Diagnostic Test Mode."
- Select "KOEO On-Demand Self Test and KOER On-Demand Self Tests."
- Carry out test and record DTCs.
- Repair all non-Transmission DTCs.
- Repair all VSS and digital TR sensor DTCs.
- Make sure that VSS and digital TR sensors are functional.
- Select "Active Command Modes."
- Select "Output State Control."
- Select "Trans - Bench Mode or Trans - Drive Mode."