Selector Lever Cable Adjustment - Column Shift

NOTE: The selector lever cable adjustment procedure must be carried out in the order shown.

Position the transaxle range selector lever in OVERDRIVE. Hang a 1.4 kg (3 lb) weight on the lever.
Loosen the manual control lever-to-selector lever cable nut.

Fig 1: Locating Manual Control Lever-To-Selector Lever Cable Nut - Column Shift
Courtesy of FORD MOTOR CO.
Position the manual control lever in OVERDRIVE then install the nut.
- Tighten to 20 Nm (15 lb-ft).
Fig 2: Locating Manual Control Lever-To-Selector Lever Cable Nut - Column Shift
Courtesy of FORD MOTOR CO.
Remove the 1.4 kg (3 lb) weight. Check the operation of the transaxle in each transaxle range selector lever position.